[. . . ] Quick Reference Guide Turning the Quest 2 On and Installing the Unit ToturnontheQuest2: Press and hold the Power on or off. key on the front of the unit to turn it Finding Places and Routing to Them 1. [. . . ] Snap the Quest 2 back into the mount so that it is fully seated. ToinstalltheQuest2inyourvehicle: To stop or resume the current route: Information Page PAGE--press to cycle through pages, close the current window or menu and return to the previous page, or cancel data entry and restore the previous value. Rocker--press up, down, right, or left to highlight options or move the map pointer. September 2006 © Copyright 2006 Garmin Ltd. A Printed in Taiwan pocket-sized navigator note: When the vehicle is moving, Safe Mode turns on automatically. If you press FInD while driving, only the Emergency & Government Services search category is available. Finding Addresses 1. Highlight the state if it appears on a button, or choose SelectState to find the correct name. 7 To create a route to this address, highlight RouteTo, and press OK. Setting Your Home Location and Resetting Trip Info 1. Highlight one of the options: Use Current Location, Use Find Menu, or Use Map, and then press OK. Your Home location is set. Finding Where You Are and Using TracBack® 1. From the Find page, highlight Where Am I?, and press OK. An information page appears, listing your current location and nearest major intersections. At the prompt, highlight Yes to TracBack to the beginning of the track, and press OK. [. . . ] The data Trip Information Page is reset. To reset the trip data or the maximum speed: Shortcuts: Press and hold FINDto navigate to your Home location. Press IN and Power if your Quest 2 freezes (stops responding to button presses). [. . . ]